Loading Via Serial Port Viewsat PRO! - Satellite and FTA Forums

Loading Via Serial Port Viewsat PRO! - Satellite and FTA Forums

As always use these instructions at your own risk!!!!!!!

Loading a Factory File
1) Make sure the VSPro is off.
2) Connect is to the COM port of your Computer
3) Start the VSPROLoader Program
4) Verify that your Com port setting is correct
5) Click "Connect"
6) Click "Upload to STB"
7) For Files types click on "All types" so that the ".opt"
files are avaiable
8) Select the VIEWSAT_VSPRO_V100.opt file or most current one
9) You'll get a new Dialog that says "Reset your STB(s)"
10) Turn on our VSPro
11) You'll get a new Dialog that says "Check displayed message
('Loader or 'mon') on the front panel, then press the OK button."
12) Verify that the front the receiver says "non" and then click OK
13) It will start reflashing by erasing the memory.
14) It should say step (1 of 2). The second step takes the longest
so don't worry if it seems like it is taking awhile.
15) Once it finishes it will say that the operation is Complete/Successful

Loading a ".all" file
1) Make sure the VSPro is off.
2) Connect is to the COM port of your Computer
3) Start the VSPROLoader Program
4) Verify that your Com port setting is correct
5) Click "Connect"
6) Click "Upload to STB"
7) Select the ".all" file that you wish to load
8) You'll get a new Dialog that says "Reset your STB(s)"
9) Turn on our VSPro
10) You'll get a new Dialog that says "Check displayed message
('Loader or 'mon') on the front panel, then press the OK button."
11) Verify that the front the receiver says "non" and then click OK
12) It will start reflashing by erasing the memory.
13) It should say step (1 of 4). The fourth step takes the longest
so don't worry if it seems like it is taking awhile.
14) Once it finishes it will say that the operation is Complete/Successful!OK

Greetings..........